FA522266 - Pinion Gear - $202.45
FA522266 - Pinion Gear - $202.45
CHRYSLER OUTBOARD close out PARTS
F2A523023 - Forward gear for 4 cylinder Chrysler outboard - see additional pics to the right. $334.50
F522116 Exhaust Snout - $47.50 USED
FA136054 Gear Housing - $92.25
FA197167 - Starter & Carb brkt $61.60
ONE USED AVAILABLE IN GOOD SHAPE.
FA474298 Bearing Cage some 55/60 & 65 + sailor models $92.25
FA486054 Gear Housing 45/50 & 55 - $194.61
FA474054 - Gear Housing some 55/60 & 65 - $187.50
FA28054 Gear Housing - $91.50
F2A474266 Pinion Gear 35/45/50 & 55 - Late - $115.75
FA141298 Bearing Cage 35/45/50 & 55hp - $139.50. Used only available at $75.00. Email for info. or invoice.
FA485662 Reverse Gear 35/45/50 & 55 - $197.46
FA485023 Forward Gear 35/45/50 & 55 - $208.86
F617674 pinion gear - $13.02
F287098 prop shaft - $166.95
Used 3 cylinder powerflo off of a 85 hp Chrysler outboard $750.00
Drained, pressure test and refilled. No water or foreign material present and bench shifts fine. I can tear down and rebuild this unit for an additional $250.00
F85965 - Used motor mounts - $34.50 ea.
Used and bench tested okay CD and coil F523301 - $375.00
Used 3 cylinder 2 piece lower unit from a 75 hp Chrysler. $650.00 Drained, pressure test and refilled. Shifts fine on the bench. No debris or water present. I can tear down and rebuild this unit for an additional $200.00
FC141054 Housing for old style pinion gear using the 09195 bearing race. This is a new part but was dropped at some time and bent the edge near where "o" ring goes. It should be a good serviceable part but we don't sell anything without foreclosure. The housing and pinion gear pictured are NLA - $675.00 for complete assembly as pictured.
FA141054 Housing for old style pinion gear using the 09195 bearing race. This is a new part but was dropped at some time and bent the edge near where "o" ring goes. It should be a good serviceable part but we don't sell anything without disclosure. Race OD = 1.940". This part is NLA. - $126.50
FA46266 old style pinion - $129.50
FTM rewind tool - $21.50
F409232 starter rope - $2.75
F286710 arbor - $37.89
FA286970 spring assy - $52.96
F459239 starter spool - $45.33
Model 67 2/4cycle (used) tachometer $175.00
FT8953 CD tester (used) $139.95
Model 7100 Merctronic ignition analyzer (used) - $399.00
F15100 - Bendix for #474955
55 and 60 hp - 1974 - 1977
Fuel Pump Kit - old style
$37.50
(1) F84760 - gasket - $4.50
(1) FO7759 - sediment bowl - $3.95
(1) F84617 - gasket - $2.50
(1) F84653 - screen - $4.67
(3) F177330 - valves - $15.39
(3) F84792 - gaskets - $2.25
Fuel Pump Kit - new style
$31.50
(1) F438760 gasket - $1.92
(1) F438617 gasket $4.04
(1) F438653 screen $3.75
(3) F177330 valves $15.39
(3) gaskets $2.25
F24544 - lock spring - $3.65
F215541 - 20hp lock - $12.20
F85541 - Tilt Latch - $18.86
F19379 - Spacer - $9.25
F562637 - SPLINE - $24.75
F521266 - PINION - $68.75
F521023 - FORWARD - $81.50
FA324094 - CONE - $7.25
FA197662 - REV - $108.72
FA197023 - FWD - $111.20
F197266 - USED PIN - $48.50
FA94094 - CONE - $8.99
F400521 - CLUTCH - $60.29
F14006 - USED 3 BASE - $70.00
F14005 - USED 4 BASE - $80.00
F85349 - REV LOCK - $33.50
F318266 - PINION $93.15
F14004 3 CYL ROTOR - $138.45
F523962 - CD MOUNTS $26.95
F14020 - 3CYL SEAL $22.50
F14011 - 3CYL CAP $34.70
F14021 - 4CYL SEAL - $22.50
F14010 - CAP - $34.70
F699562 - PLATE - $9.25
F2A522023 - Forward - $189.75
FA522662 - Reverse - $179.35
F14003 4 CYL ROTOR - $147.95
FA522098 - Propshaft - $281.25